inf_ACME-Stop

Serving the Globe since the last millennium
And
Beyond

Track & Confirm

Here

Services

Products

Ordering

Links

Support

Contact

About Us

Care and Use information

click to return toACM.E-Stop product sheet

ACM.E-Stop:
Installation:

Simply connect the Plug to the wall outlet 120VAC@15A maximum.

Then insert the device plug into the weather resistant outlet box.

Pull the Stop button until the button pops up fully.

The circuit should now be active.

Specifications:

The circuit is designed to meet state and local electrical codes. The capacity for the component attached is 15amp @ 120VAC maximum. The assembly is splash resistant when properly installed and can remain at bench level without fear of a shock hazard. All covers and connectors must remain intact to maintain this capacity.

Operation:

This circuit interrupter can provide any AC powered device requiring less than 15 Amps AC with added safety. The outlet is a Ground Fault Circuit Interrupt protected circuit. Should a grounding fault be detected, you can reset the circuit by opening the lid and depressing the outlet ‘Reset’ button. You can test this function by depressing the outlet ‘Test’ button, then reset for proper operation.

Trouble shooting:

Should the Component ground fail the GFCI reset button inside the receptacle will pop up. It can be reset with the adjacent ‘Reset’ button. If interrupter trips without any device plugged in then a fault in the wall receptacle will need to be serviced. If the circuit trips when a device is plugged into it, then the component plugged into the outlet should be serviced to locate the ground fault.

{ ACME-Automation Home }