Care and Use information

             click to return to Dynamifold product sheet
 

DynamifoldÔ
This is self adjusting vacuum filtration manifold for use with various automated liquid handlers and manual benchtop laboratory use.

Automated Use:
Redefine the manifold dimensions for your liquid handling biorobotics platform. The labook dimensions are included later in this document. Electronic labbooks are available for the Biomek 2000. When the collar is not on the manifold it should reside in the collar holder. This collar holder fits inside a standard labware holder registering the collar at the same time it can locate and cool a shallow piece of labware.

Dimensions:

Operation:
Select the correct collar to perform the task. There should be no more than 5/16" between the current and rested seating position. If the collar is acceptable then proceed with a sealing test by placing the wetted filter plate and desired receptor plate inside the manifold. Activate manifold and adjust the maximum vacuum level. Set up according to your method and begin the process.

  Lysis wash to Elution

Valve control (Optional)
There are various valve control options for this device. From Basic and advanced electronic software control to a manual toggle valve. Refer to the valve documentation for instructions or call JCahlik @ACME-Automation.com (714) 225-2493

Software (Optional)

When the automated software valve control option is used, the Dynamifold functions as a fully automated system for maximum ‘Walk-away Time’. All that is required is toclose all open applications and to run setup from the supplied disk. The BioWorks Labbook has examples of the Programs use and definitions for there use.

Gasket installation
The thick .375 gasket is for the base. Although included it is not required to use the adhesive seal to seal the gasket in place. After a vacuum test to check operation.

The thin gasket is used for the manifold collar. The gasket can be easily stretched when installing it. Apply inverted to simplify the installation process. Anchor the corners and then position the straight portions.

Clean-up

  1. Chemical Sterilization: Use of most commonly available disinfectants can be used. Avoid prolonged exposure to the more aggressive disinfectants to avoid any surface cracking.
  2. Autoclaving: Do not autoclave.