Care and Use information

 

             click to return to MINIVOIR96 w/LID product sheet
Minivoir96ä

This is a low volume reservoir for use with various automated liquid handlers and manual laboratory use.

Automated Use:

Define the reservoir using the respective software utilities for your Liquid handler.

To do this refer to the following dimensions. *Tip: the well access locations , Length and width dimensions are the same as a standard 96 well microplate.

Dimensions:

  1. Minivoir96 Height: ……….. 19 mm
  2. Max trough Depth:……….. 16.75mm (24.75mm lid on)
  3. Lid on Height:……………... 26mm
  4. Lid well Diameter: ………... 6.5mm
  5. Max Tip-Touch Depth: …… 9.5mm (64-100% of total height)
  6. X wide: ……………………... 127.6mm
  7. Y narrow: ………………….. 85.8mm
  8. A1 to -X edge: …………… 14.25mm (96well flat locations)
  9. A1 to -Y edge: ……………. 11.32mm

Specifications:

Minimum wetting volume:. 1ml

Max safe capacity: ……….. 130ml

Material: ……………………. HD Polypropylene

 

Operation:

For the best operational performance, the reservoir base must remain as flat and level as possible. DO not fill above 130ml or the lid installation will spill some of the contents.

Clean-up

  1. Chemical Sterilization: Use of most commonly available disinfectants can be used. Avoid prolonged exposure to the more aggressive disinfectants to avoid any surface cracking. LID should be sterilized.
  2. Autoclaving: Rinse clean in DI water prior to periods of autoclaving. 
    121° C / 15 psi. Cycle length of 15 minutes minimum duration. The cycle period varies according to the type of chemical / material exposure. Proper periods can only be determined with experience.    Care should be taken if autoclaving LID, It may warp under autoclaving.